Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM2040EQ _54 Brake _014708 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0074983 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.


PROCEDURE

Hide 84306 1.INSPECT SPIRAL CABLE SUB-ASSEMBLY

Hide 89245B 2.INSTALL STEERING SENSOR

a.
C238436C04
2.177,0.583 1.906,0.271 false 2.396,0.781 2.156,1.458 2.156,1.458 2.438,1.26 false 2.99,0.302 2.885,0.302 2.885,0.302 2.885,0.885 false 0.406,0.396 0.51,0.396 0.51,0.396 0.51,0.917 false 1.75,0.177 1.99,0.406 0.24,0.229 10 false *1 2.01,1.396 2.229,1.625 0.219,0.229 10 false *a 3.031,0.208 3.271,0.458 0.24,0.25 10 false *b 0.24,0.302 0.469,0.573 0.229,0.271 10 false *b
*1 Lock Pin
*a Guide
*b Pin


Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.

NOTICE:
·

Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

·

Do not damage the pins of the spiral cable sub-assembly and guides of the steering sensor.

·

The spiral cable sub-assembly can be rotate up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.




b.
C238437

Remove the lock pin from the steering sensor.


Hide 3. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

Hide 4.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY