Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID
RM2040EQ _54 Brake _014709 BRAKE SYSTEM (OTHER) _0074986 BRAKE FLUID G

BRAKE SYSTEM (OTHER)  BRAKE FLUID  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid. Sealed areas may deteriorate and lead to fluid leaks, or the fluid may deteriorate and lead to decreased efficiency.


HINT:

If the brake fluid level is lower than the MIN line, inspect for brake fluid leaks and brake pad wear. After repair or replacement, adjust the brake fluid level in the reservoir as specified below.


PROCEDURE

Hide 1.INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (for Using the intelligent tester)

a.

Connect the intelligent tester to the DLC3 with the power switch off.


b.

Check that the shift lever is in P and the parking brake is applied, and turn the power switch on (IG).


c.

Turn the intelligent tester on and enter the following menus: Chassis / ABS/VSC/TRC / Utility / ECB (Electronically Controlled Brake system) Utility / Zero Down.

Chassis > ABS/VSC/TRC > Utility
Tester Display
ECB Utility
50005 105 167

d.

Select "Next" and wait for 10 seconds.


e.
C242737
1.094,1.229 1.094,1.646 false 1.042,0.969 1.042,0.615 1.042,0.615 1.146,0.615 false 1.177,0.521 1.427,0.75 0.25,0.229 10 false *a 1.021,1.635 1.26,1.865 0.24,0.229 10 false *b
*a MAX Line
*b MIN Line


After the booster pump has stopped, inspect that the fluid level is between the MAX and MIN lines. If necessary, refill the brake fluid to the MAX line.

Brake fluid:

SAE J1703 or FMVSS No. 116 DOT3



Hide 2.INSPECT AND ADJUST FLUID LEVEL IN RESERVOIR (for not Using the intelligent tester)

a.
C242737
0.938,1.021 0.74,1.219 0.74,1.219 0.656,1.219 false 0.5,1.135 0.75,1.365 0.25,0.229 10 false *a
*a Fluid Level Support Line


Inspect that the fluid level is above the MIN line with the power switch on (IG). If necessary, refill the brake fluid to the fluid level support line with the power switch on (IG).

Brake fluid:

SAE J1703 or FMVSS No. 116 DOT3