Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM2040EQ _54 Brake _014710 BRAKE (FRONT) _0074990 FRONT BRAKE A

BRAKE (FRONT)  FRONT BRAKE  REASSEMBLY  


PROCEDURE

Hide 47547B 1.TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG

HINT:

Fully tighten the front disc brake bleeder plug after bleeding.


Hide 31478B 2.INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.
C239542
1.604,1.229 1.625,1.229 false
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.


b.

Install the piston seal to the front disc brake cylinder.

NOTICE:

Securely install the piston seal to the groove of the front disc brake cylinder.



Hide 47731 4.INSTALL FRONT DISC BRAKE PISTON

a.
C239543
1.031,0.969 1.156,0.969 false 0.99,1.948 1.177,1.948 false 1.198,0.885 1.427,1.115 0.229,0.229 10 false *1 1.208,1.854 1.417,2.073 0.208,0.219 10 false *2
*1 Cylinder Boot
*2 Front Disc Brake Piston
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.


b.

Install the cylinder boot to the front disc brake piston.


c.

Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston, and install it to the front disc brake cylinder.

NOTICE:

Do not install the front disc brake piston forcibly in the front disc brake cylinder.



Hide 5.INSTALL CYLINDER BOOT

a.
C239544
0.594,0.74 0.594,1.063 false 1.125,0.865 1.125,1.063 false 0.51,1.073 0.729,1.313 0.219,0.24 10 false *1 1.042,1.073 1.281,1.313 0.24,0.24 10 false *2
*1 Front Disc Brake Piston Set Ring
*2 Cylinder Boot


Install the cylinder boot to the front disc brake cylinder.

NOTICE:

Securely install the cylinder boot to the groove of the front disc brake cylinder and front disc brake piston.



b.
C239579
1.781,1.469 2.021,1.708 2.021,1.708 2.188,1.708 false 2.219,1.615 2.469,1.833 0.25,0.219 10 false *1
*1 Vinyl Tape


Using a screwdriver, install a new front disc brake piston set ring.

NOTICE:
·

Securely install the front disc brake piston set ring to the outer groove of the cylinder boot.

·

Do not damage the cylinder boot.