Home › Brake › BRAKE (REAR) › REAR BRAKE
RM2040EQ _54 Brake _014711 BRAKE (REAR) _0074992 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE CYLINDER BOOT

a.
C239551
1.802,1.406 1.542,1.667 1.542,1.667 1.281,1.667 false 1.135,1.583 1.458,1.833 0.323,0.25 10 false *1
*1 Vinyl Tape


Using a screwdriver with its tip wrapped with vinyl tape, remove the rear disc brake piston set ring and cylinder boot from the rear disc brake cylinder assembly.

NOTICE:

Be careful not to damage the rear disc brake piston or rear disc brake cylinder.



Hide 47731B 2.REMOVE REAR DISC BRAKE PISTON

a.
C238506

Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder.


b.

Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder.

CAUTION:

Do not place your fingers in front of the rear disc brake piston when using compressed air.


NOTICE:

Do not allow any brake fluid to spatter.



Hide 3.REMOVE PISTON SEAL

a.
C239552
1.906,1.344 2.385,1.813 2.385,1.813 2.531,1.813 false 2.552,1.729 2.833,1.99 0.281,0.26 10 false *1
*1 Vinyl Tape


Using a screwdriver with its tip wrapped with vinyl tape, remove the piston seal from the disc brake cylinder.

NOTICE:

Do not damage the inner surface or piston seal groove of the cylinder.



Hide 31478C 4.REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

Hide 47547C 5.REMOVE REAR DISC BRAKE BLEEDER PLUG