Home › Brake › BRAKE (REAR) › REAR BRAKE
RM2040EQ _54 Brake _014711 BRAKE (REAR) _0074992 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REASSEMBLY  


PROCEDURE

Hide 47547C 1.TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG

HINT:

Fully tighten the rear disc brake bleeder plug after bleeding the system.


Hide 31478C 2.INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

Hide 3.INSTALL PISTON SEAL

a.
C239553
1.583,1.323 1.594,1.313 false
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.


b.

Install the piston seal to the rear disc brake cylinder.

NOTICE:

Securely install the piston seal to the groove of the rear disc brake cylinder.



Hide 47731B 4.INSTALL REAR DISC BRAKE PISTON

a.
C239554
0.969,1.115 1.135,1.115 false 0.917,2.125 1.135,2.125 false 1.167,1.021 1.469,1.323 0.302,0.302 10 false *1 1.167,2.031 1.438,2.313 0.271,0.281 10 false *2
*1 Cylinder Boot
*2 Rear Disc Brake Piston
V100155

Lithium Soap Base Glycol Grease


Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.


b.

Install the cylinder boot to the rear disc brake piston.


c.

Apply a light layer of lithium soap base glycol grease to the contact surfaces of the rear disc brake piston, and install it to the rear disc brake cylinder.

NOTICE:

Do not install the rear disc brake piston forcibly in the rear disc brake cylinder.



Hide 5.INSTALL CYLINDER BOOT

a.
C239555
0.833,0.948 0.833,1.229 false 1.365,1.073 1.365,1.219 false 0.75,1.229 0.979,1.5 0.229,0.271 10 false *1 1.292,1.229 1.521,1.49 0.229,0.26 10 false *2
*1 Set Ring
*2 Cylinder Boot


Install the cylinder boot to the rear disc brake cylinder.

NOTICE:

Securely install the cylinder boot to the groove of the rear disc brake cylinder and rear disc brake piston.



b.

Using a screwdriver with its tip wrapped with vinyl tape, install a new rear disc brake piston set ring.

NOTICE:
·

Securely install the rear disc brake piston set ring to the outer groove of the cylinder boot.

·

Do not damage the cylinder boot.