Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2040EQ _55 Steering _014713 POWER ASSIST SYSTEMS _0074999 POWER STEERING SYSTEM D

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


NOTICE:
·

It is difficult to show the specified values (judgment values) clearly because freeze frame data values change significantly due to differences in measurement conditions, surroundings, or vehicle conditions. For this reason, there may be a problem even when the values are within specifications.

·

Turn the power switch on (IG) and park the vehicle on level ground. Check the freeze frame data by using the intelligent tester.



a.

Turn the power switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the intelligent tester on.


e.

Check the freeze frame data on the intelligent tester.

Chassis > EMPS
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Meter Vehicle Velocity Vehicle speed from meter Min.: 0.0 km/h (0.0 mph)
Max.: 300.0 km/h (186.4 mph)
·

Power switch on (READY) and vehicle stopped: 0 km/h (0 mph)

·

Power switch on (READY) and vehicle driven at a constant speed: No significant fluctuation


-
Motor Actual Current Amount of current to motor Min.: -327.68 A
Max.: 327.67 A
Power switch on (READY) and steering wheel being turned: The value rises -
Command Value Current Requested current to motor Min.: -327.68 A
Max.: 327.67 A
Power switch on (READY) and steering wheel being turned: Value changes in proportion to steering effort
-The value increases when turning left and decreases when turning right
-
Steering Angle Velocity Steering angle speed Min.: -32768 deg/s
Max.: 32767 deg/s
Power switch on (READY) and steering wheel being turned: Value changes in proportion to steering speed
-The value increases when turning left and decreases when turning right
-
Thermistor Temperature ECU substrate temperature Min.: -40.0°C (-40.0°F)
Max.: 150.0°C (302.0°F)
Power switch on (READY): -40°C to 150°C (-40°F to 302°F) -
PIG Power Supply Power source voltage to active motor Min.: 0.0000 V
Max.: 20.1531 V
Power switch on (READY) and steering wheel being turned: 9 to 16 V -
IG Power Supply IG power source voltage Min.: 0.0000 V
Max.: 20.1531 V
Power switch on (IG): 9 to 16 V -
Steering Wheel Torque Steering wheel torque Min.: -327.68 Nm
Max.: 7.00 Nm
Power switch on (READY) and steering wheel being turned: Value changes in proportion to steering effort
-The value increases when turning left and decreases when turning right
-
Motor Rotation Angle Motor rotation angle Min.: 0.000 deg
Max.: 1441.770 deg
Power switch on (READY) and steering wheel being turned: During steering operation, motor rotation angle value changes from 0 to 360° -
Motor Voltage Motor power supply voltage Min.: 0.000 V
Max.: 98.000 V
Power switch on (READY) and steering wheel being turned: 9 to 16 V -
Motor Terminal Volt(U) Motor terminal voltage (A phase) Min.: 0.000 V
Max.: 98.000 V
Power switch on (READY) and steering wheel being turned: Value changes within 4 to 35 V range -
Motor Terminal Volt(V) Motor terminal voltage (B phase) Min.: 0.000 V
Max.: 98.000 V
Power switch on (READY) and steering wheel being turned: Value changes within 4 to 35 V range -
Motor Terminal Volt(W) Motor terminal voltage (C phase) Min.: 0.000 V
Max.: 98.000 V
Power switch on (READY) and steering wheel being turned: Value changes within 4 to 35 V range -
Torque Sensor 1 Output Torque sensor voltage Min.: 0.0000 V
Max.: 4.9725 V
·

Power switch on (READY) and steering wheel not being turned (without load): 2.3 to 2.7 V

·

Power switch on (READY) and steering wheel being turned to the right with vehicle stopped: 2.5 to 4.7 V

·

Power switch on (READY) and steering wheel being turned to the left with vehicle stopped: 0.3 to 2.5 V


-
Torque Sensor 2 Output Torque sensor voltage Min.: 0.0000 V
Max.: 4.9725 V
·

Power switch on (READY) and steering wheel not being turned (without load): 2.3 to 2.7 V

·

Power switch on (READY) and steering wheel being turned to the right with vehicle stopped: 0.3 to 2.5 V

·

Power switch on (READY) and steering wheel being turned to the left with vehicle stopped: 2.5 to 4.7 V


-
Battery Voltage Auxiliary battery voltage Min.: 0.0 V
Max.: 25.5 V
9 to 16 V: Power switch on (IG) -
PS Assist Signal Power steering assist signal ON or OFF OFF: Power switch on (IG)
ON: Power switch on (READY)
-
Ready Status Ready status Ready or OFF Ready or OFF -