Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM2040EQ _55 Steering _014714 STEERING COLUMN _0075002 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REMOVAL  


PROCEDURE

Hide 2.TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

Hide 3.REMOVE FRONT WHEEL

Hide 45130 4.REMOVE HORN BUTTON ASSEMBLY

Hide 45100 5.REMOVE STEERING WHEEL ASSEMBLY

Hide 73900 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

Hide 45287 7.REMOVE LOWER STEERING COLUMN COVER

a.
C243078

Remove the 2 screws.


b.
C243079

Push the right and left sides of the lower steering column cover, and disengage the 2 claws.


c.
C243080

Insert a finger into the opening of the tilt lever of the lower steering column cover to disengage the claw and remove the lower steering column cover.


Hide 45286B 8.REMOVE UPPER STEERING COLUMN COVER

a.
C243081

Disengage the 4 clips and 2 guides from the upper steering column cover.


b.
C243082

Disengage the 2 claws to remove the upper steering column cover.


Hide 9.REMOVE TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the auxiliary battery connected and the power switch on (IG).

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.



a.

Disconnect the connectors from the turn signal switch assembly with spiral cable sub-assembly.


b.
C244041

Disengage the 3 claws to remove the turn signal switch assembly with spiral cable sub-assembly from the steering post assembly.


Hide 45220 10.SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C243084

Using a screwdriver, loosen the clamp as shown in the illustration.


b.
C243088C02
1.792,0.906 2.354,1.219 2.354,1.219 1.802,0.99 false 2.354,1.115 2.604,1.385 0.25,0.271 10 false *a
*a Matchmark


Put matchmarks on the steering intermediate shaft assembly and the steering link assembly.


c.

Remove the bolt and separate the steering intermediate shaft assembly from the steering link assembly.


Hide 87201B 11.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY

a.
C239720

Remove the bolt.


b.

Disengage the 2 claws to remove the No. 2 air duct sub-assembly.


Hide 12.REMOVE STEERING POST ASSEMBLY

a.

Disconnect the connectors and disengage the wire harness clamps from the steering post assembly.


b.
C243086

Disconnect the 2 connectors.


c.
C243087

Disengage the clamp.


d.
C243089

Remove the bolt to separate the ground wire.


e.

Remove the 4 nuts and the steering post assembly.


Hide 45220 13.REMOVE STEERING INTERMEDIATE SHAFT ASSEMBLY

a.
C243095C02
2.656,1.469 2.74,1.802 2.74,1.802 2.76,1.458 false 2.656,1.792 2.906,2.063 0.25,0.271 10 false *a
*a Matchmark


Remove the bolt and slide the steering intermediate shaft assembly.

NOTICE:

Do not remove the steering intermediate shaft assembly from the steering column assembly.



b.

Put matchmarks on the steering intermediate shaft assembly and the steering column assembly.


c.

Remove the steering intermediate shaft assembly from the steering column assembly.