Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM2040EQ _55 Steering _014714 STEERING COLUMN _0075002 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  DISASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, do not overtighten it.

·

Do not drop the power steering ECU with motor assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU with motor assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness of the electric power steering column sub-assembly.

·

Do not allow any moisture to come into contact with the power steering ECU with motor assembly.

·

Do not loosen any bolts not mentioned in the procedure.



PROCEDURE

Hide 45020A 1.REMOVE STEERING LOCK ACTUATOR ASSEMBLY

a.

Using a center punch, mark the center of the 2 tapered-head bolts.


b.

Using a 3 to 4 mm (0.118 to 0.157 in.) diameter drill bit, drill a hole in each tapered-head bolt.


c.
C236195

Using a screw extractor, remove each tapered-head bolt, and then remove the steering lock actuator assembly from the steering column assembly.


Hide 8965A 2.REMOVE POWER STEERING ECU PROTECTOR

a.
C244042

Disengage the 2 claws to remove the power steering ECU protector from the power steering ECU with motor assembly.


Hide F1901 3.REMOVE ECU WIRE SUB-ASSEMBLY

a.
C243096

Disconnect the 2 connectors from the power steering ECU with motor assembly.


b.

Disengage the 2 wire harness clamps to remove the ECU wire sub-assembly.


Hide 4.REMOVE POWER STEERING ECU WITH MOTOR ASSEMBLY

a.
C243097
0.979,1.135 0.979,0.823 0.979,0.823 0.635,0.823 false 2.375,1.615 2.635,1.615 false 0.49,0.75 0.781,0.99 0.292,0.24 10 false *1 2.656,1.521 2.948,1.813 0.292,0.292 10 false *2
*1 Aluminum Plate
*2 Wooden Block


Secure the steering column assembly in a vice using aluminum plates as shown in the illustration.

NOTICE:
·

Do not overtighten the vice, as the steering column assembly may become deformed.

·

Support the steering column assembly with a wooden block or similar item to ensure that it does not fall.




b.
C243098

Disconnect the 2 connectors from the power steering ECU with motor assembly.


c.
C243099

Remove the 2 bolts and power steering ECU with motor assembly from the electric power steering column sub-assembly.


d.
C239326

Remove the O-ring from the power steering ECU with motor assembly.


Hide 89650 5.REMOVE POWER STEERING ECU ASSEMBLY