Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM
RM2040EQ _55 Steering _014714 STEERING COLUMN _0075005 STEERING LOCK SYSTEM D

STEERING COLUMN  STEERING LOCK SYSTEM  DTC CHECK / CLEAR  


NOTICE:
·

The steering lock ECU does not store past DTCs. If any DTCs are output, confirm and record them as soon as possible. Do not turn the power switch off or clear the DTCs until the DTCs are confirmed and recorded.

·

DTCs may have been stored due to problems unrelated to the steering lock system. Be sure to confirm and record any DTCs output for other systems.

·

When using the intelligent tester with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins, or 2) connect the intelligent tester to the vehicle and select "Manual" from the initial screen on the intelligent tester. Select "Key Code Registration" under model code.



CHECK FOR DTC (POWER MANAGEMENT CONTROL ECU)


a.

Turn the power switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the intelligent tester on.


e.

Enter the following menus: Body / Power Source Control / DTC.

Body Electrical > Power Source Control > Trouble Codes
50001 223

f.

Check for DTCs.



CHECK FOR DTC (MAIN BODY ECU)


a.

Turn the power switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the intelligent tester on.


e.

Enter the following menus: Body / Main Body / DTC.

Body Electrical > Main Body > Trouble Codes
50001 123

f.

Check for DTCs.



CHECK FOR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))


HINT:

The steering lock system DTCs are output from the steering lock ECU via the certification ECU (smart key ECU assembly).


a.

Turn the power switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the intelligent tester on.


e.

Enter the following menus: Body / Entry&Start / DTC.

Body Electrical > Entry&Start > Trouble Codes
50001 125

f.

Check for DTCs.



CLEAR DTC (POWER MANAGEMENT CONTROL ECU)


a.

Turn the power switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the intelligent tester on.


e.

Enter the following menus: Body / Power Source Control / DTC.

Body Electrical > Power Source Control > Clear DTCs
50002 223

f.

Clear the DTCs.



CLEAR DTC (MAIN BODY ECU)


a.

Turn the power switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the intelligent tester on.


e.

Enter the following menus: Body / Main Body / DTC.

Body Electrical > Main Body > Clear DTCs
50002 123

f.

Clear the DTCs.



CLEAR DTC (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))


a.

Turn the power switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the power switch on (IG).


d.

Turn the intelligent tester on.


e.

Enter the following menus: Body / Entry&Start / DTC.

Body Electrical > Entry&Start > Clear DTCs
50002 125

f.

Clear the DTCs.