45470
1.INSPECT TIE ROD ASSEMBLY
Secure the tie rod assembly in a vise.
Do not overtighten the vise.
Install the nut to the stud bolt.
Flip the ball joint back and forth 5 times.
Set a torque wrench to the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.
1.0 to 4.0 N*m (10 to 40 kgf*cm, 9 to 35 in.*lbf)
If the turning torque is not within the specified range, replace the tie rod assembly.
2.INSPECT TOTAL PRELOAD
Inspect the total preload in a no-load condition by removing the tie rod assembly RH and LH, and steering rack boots.
Install SST to the pinion shaft and turn it left and right 5 times or more.
Set a torque wrench to SST and turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.
0.7 to 1.2 N*m (8 to 12 kgf*cm, 7 to 10 in.*lbf)
Inspect the total preload around the steering rack center position.
If the total preload is not within the specified range, replace the steering gear assembly with a new one.