Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR MAIN SWITCH
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075028 BLIND SPOT MONITOR MAIN SWITCH A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR MAIN SWITCH  REMOVAL  


PROCEDURE

Hide 55446A 1.REMOVE NO. 1 SWITCH HOLE BASE

a.
E234562
1.281,1.198 0.833,0.979 true 0.667,0.885 0.927,1.094 0.26,0.208 10 true *1
*1 Protective Tape


Apply protective tape to the areas shown in the illustration.


b.

Using a moulding remover, disengage the 4 claws and 2 guides as shown in the illustration.


c.

Disconnect the connector and remove the No. 1 switch hole base.


Hide 84470 2.REMOVE BLIND SPOT MONITOR MAIN SWITCH ASSEMBLY (WARNING CANCELING SWITCH ASSEMBLY)

a.
E234563

Disengage the 2 claws to remove the blind spot monitor main switch assembly (warning canceling switch assembly).