Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR(for Rear Side) › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075030 ULTRASONIC SENSOR(for Rear Side) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Rear Side)  INSTALLATION  


PROCEDURE

Hide 89348 1.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

a.
E232468C03
1.542,1.823 1.344,2.021 false 2.219,3.073 2.406,2.885 false 0.979,3.104 0.813,3.271 false 2.771,1.792 2.938,1.625 false 2.969,1.531 3.125,1.688 0.156,0.156 10 *a 1.167,1.979 1.323,2.135 0.156,0.156 10 *b 0.083,0.073 0.375,0.333 0.292,0.26 12 *A 0.073,2.427 0.438,2.677 0.365,0.25 12 *B 0.594,3.198 0.75,3.354 0.156,0.156 10 *a 2.427,2.802 2.583,2.958 0.156,0.156 10 *b
*A LH Side
*B RH Side
*a Keyhole
*b Snap


Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.

NOTICE:
·

Do not damage the front bumper with the protrusion when installing the retainer.

·

Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.



HINT:

When installing the retainer, align the keyhole and snap as shown in the illustration.



Hide 89341A 2.INSTALL NO. 1 ULTRASONIC SENSOR

a.
E228019C05
0.063,2.448 0.344,2.677 0.281,0.229 12 *B 0.063,0.052 0.375,0.302 0.313,0.25 12 *A
*A LH Side
*B RH Side


Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

NOTICE:

Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.



Hide 89348J 3.INSTALL ULTRASONIC SENSOR CLIP

a.
E228018C03
0.083,2.313 0.365,2.542 0.281,0.229 12 *B 0.083,0.063 0.365,0.292 0.281,0.229 12 *A
*A LH Side
*B RH Side


Engage the 4 claws to install the ultrasonic sensor clip.


b.
E265614C05
0.146,0.219 0.708,0.5 0.563,0.281 12 *A 0.198,2.344 0.74,2.708 0.542,0.365 12 *B
*A LH Side
*B RH Side


Engage the clamp.


c.

Connect the connector.


Hide 4.INSTALL REAR BUMPER ASSEMBLY