Home › Power Source / Network › POWER DISTRIBUTION › MAIN BODY ECU
RM2040EQ _57 Power Source / Network _014720 POWER DISTRIBUTION _0075038 MAIN BODY ECU A

POWER DISTRIBUTION  MAIN BODY ECU  REMOVAL  


PROCEDURE

Hide 89681A 1.REMOVE POWER MANAGEMENT CONTROL ECU

Hide 82730 2.REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

a.
B287217

Disconnect the 5 connectors.


b.
B281439

Remove the bolt, nut and disconnect the instrument panel junction block assembly.


c.
B281440

Remove the nut.


d.

Disengage the claw as shown in the illustration and remove the wiring harness clamp bracket.


e.
B279018

Disengage the claw and disconnect the connector as shown in the illustration.


f.
B279020

Disengage the claw and release the connector lock as shown in the illustration.


g.
B279022

Disengage the claw and disconnect the connector as shown in the illustration.


h.

Remove the instrument panel junction block assembly.


Hide 89221 3.REMOVE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

a.
B286745
0.396,2.875 0.396,3.25 false 0.5,2.969 0.677,3.24 false 1.771,2.448 1.552,2.917 false 0.344,3.26 0.656,3.417 0.313,0.156 10 *1 0.667,3.25 0.979,3.406 0.313,0.156 10 *2 1.448,2.938 1.76,3.094 0.313,0.156 10 *3
*1 Main Body ECU (Multiplex Network Body ECU)
*2 Claw of Driver Side Junction Block
*3 Protective Tape


Press the claw of the junction block as shown in the illustration to release the lock.


b.

With the junction block lock released, insert a screwdriver with its tip wrapped with protective tape horizontally between the main body ECU (multiplex network body ECU) and junction block.

NOTICE:

Use a screwdriver with a diameter of between 5.0 mm (0.197 in.) and 6.3 mm (0.248 in.) and a length of approximately 90 mm (3.54 in.).



c.
B286746
1.76,1.708 2.24,1.708 false 2.25,1.625 2.583,1.854 0.333,0.229 10 false *1
*1 Protective Tape


Using the screwdriver, carefully raise the main body ECU (multiplex network body ECU) up to the position where the connector becomes disengaged.

NOTICE:

Do not insert the screwdriver opening between the junction block and the connector of the main body ECU (multiplex network body ECU). Do not twist the screwdriver to raise the main body ECU (multiplex network body ECU).



d.
B286747
0.406,0.427 0.719,0.719 0.313,0.292 10 false (1) 2.333,1.563 2.677,1.875 0.344,0.313 10 false (2)

Raise the main body ECU (multiplex network body ECU) as shown by the arrow (1), and then pull it out as shown by the arrow (2) in the illustration.

NOTICE:

Do not touch the ECU connector.