OVERALL CAN BUS DIAGRAM
Control system CAN is composed of 4 buses.
| *A | for Navigation Receiver Type | *B | for Radio and Display Type |
| *C | w/ Seat Position Memory | *D | w/ Blind Spot Monitor System |
| *E | w/ Automatic High Beam System | - | - |
| *1 | V Bus | *2 | Sub Bus 1 |
| *3 | Sub Bus 11 | *4 | Sub Bus 15 |
| *5 | V Bus Terminating Resistor | *6 | Sub Bus 1 Terminating Resistor |
| *7 | Sub Bus 11 Terminating Resistor | *8 | Sub Bus 15 Terminating Resistor |
| *9 | ECM
(for V Bus and Sub Bus 15) |
*10 | Main Body ECU (Multiplex Network Body ECU)
(for V Bus and Sub Bus 1) |
| *11 | Navigation ECU Sub-assembly
(for V Bus) |
*12 | Radio and Display Receiver Assembly
(for V Bus) |
| *13 | Airbag Sensor Assembly
(for V Bus) |
*14 | Power Management Control ECU
(for V Bus, Sub Bus 11 and Sub Bus 15) |
| *15 | Air Conditioning Amplifier Assembly
(for V Bus) |
*16 | Power Steering ECU Assembly
(for V Bus) |
| *17 | Steering Sensor
(for V Bus) |
*18 | DLC3
(for V Bus) |
| *19 | Brake Booster with Master Cylinder Assembly (Skid Control ECU)
(for V Bus and Sub Bus 15) |
*20 | Smart Key ECU Assembly (Certification ECU)
(for V Bus) |
| *21 | Headlight Swivel ECU Assembly (AFS ECU)
(for V Bus) |
*22 | Combination Meter Assembly
(for V Bus) |
| *23 | Outer Mirror Control ECU Assembly (for Front Passenger Side)
(for Sub Bus 1) |
*24 | Outer Mirror Control ECU Assembly (for Driver Side)
(for Sub Bus 1) |
| *25 | Position Control ECU and Switch Assembly (for Driver Side)
(for Sub Bus 11) |
*26 | CAN Junction Connector RH2
(for Sub Bus 1) |
| *27 | Blind Spot Monitor Sensor RH
(for Sub Bus 11) |
*28 | Blind Spot Monitor Sensor LH
(for Sub Bus 11) |
| *29 | CAN No. 4 Junction Connector
(for Sub Bus 11) |
- | - |
The main body ECU (multiplex network body ECU) functions as a gateway between the V bus and sub bus 1.
The power management control ECU functions as a gateway between the V bus and sub bus 11.
Refer to the following bus wiring diagrams for details.
V BUS
The CAN communication system connects to other network via ECUs that function as a gateway.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>SYSTEM DIAGRAM
SUB BUS 1 (w/ Seat Position Memory System)
SUB BUS 11 (w/ Blind Spot Monitor System)
SUB BUS 15