Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL SWITCH
RM2040EQ _58 Vehicle Interior _014722 DOOR LOCK _0075045 DOOR CONTROL SWITCH G

DOOR LOCK  DOOR CONTROL SWITCH  INSPECTION  


PROCEDURE

Hide 84820 1.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

a.

Check the operation of the power window regulator master switch assembly

i.
B295736
0.469,3.219 0.469,1.958 0.469,1.958 0.792,1.958 false 0.604,3.229 0.604,2.479 0.604,2.479 0.781,2.479 false 1.448,3.229 1.448,2.479 1.448,2.479 1.688,2.479 false 0.146,0.115 0.385,0.344 0.24,0.229 10 false *a 0.823,2.406 1.104,2.625 0.281,0.219 10 false UL 0.833,1.875 1.042,2.115 0.208,0.24 10 false E 1.729,2.396 1.938,2.625 0.208,0.229 10 false L
*a Component without harness connected
(Power Window Regulator Master Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (L) - 9 (E) Lock switch pushed Below 1 Ω
2 (L) - 9 (E) off 10 kΩ or higher
8 (UL) - 9 (E) Unlock switch pushed Below 1 Ω
8 (UL) - 9 (E) off 10 kΩ or higher


If the result is not as specified, replace the power window regulator master switch assembly.