DATA LIST
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ACC SW | Power switch | ON or OFF | ON: Power switch on (ACC)
OFF: Power switch off |
- |
| IG SW | Power switch | ON or OFF | ON: Power switch on (IG)
OFF: Power switch off |
- |
| RR Door Courtesy SW | Rear door courtesy light switch RH | CLOSE or OPEN | CLOSE: Rear door RH closed
OPEN: Rear door RH open |
- |
| RL Door Courtesy SW | Rear door courtesy light switch LH | CLOSE or OPEN | CLOSE: Rear door LH closed
OPEN: Rear door LH open |
- |
| FR Door Lock Pos | Front door RH unlock detection switch | LOCK or UNLOCK | LOCK: Front door RH locked
UNLOCK: Front door RH unlocked |
- |
| FR Door Courtesy SW | Front door courtesy light switch RH | CLOSE or OPEN | CLOSE: Front door RH closed
OPEN: Front door RH open |
- |
| FL Door Lock Pos | Front door LH unlock detection switch | LOCK or UNLOCK | LOCK: Front door LH locked
UNLOCK: Front door LH unlocked |
- |
| FL Door Courtesy SW | Front door courtesy light switch LH | CLOSE or OPEN | CLOSE: Front door LH closed
OPEN: Front door LH open |
- |
| Hood Courtesy SW | Engine hood courtesy switch | ON or OFF | ON: Engine hood open
OFF: Engine hood closed |
- |
| RR-Door Lock Pos SW | Rear door RH unlock detection switch | ON or OFF | ON: Rear door RH or LH unlocked
OFF: Rear door RH and LH locked |
- |
| RL-Door Lock Pos SW | Rear door LH unlock detection switch | ON or OFF | ON: Rear door LH or RH unlocked
OFF: Rear door LH and RH locked |
- |
| Luggage Courtesy SW | Luggage compartment door courtesy switch | ON or OFF | ON: Luggage compartment door open
OFF: Luggage compartment door closed |
- |
ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body or Entry&Start / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Vehicle Horn | Vehicle horns | ON / OFF | - |
| Security Horn | Security horn | ON / OFF | - |
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Immobiliser Indicator | Security indicator light | ON / OFF | - |