81240
1.REMOVE NO. 1 ROOM LIGHT ASSEMBLY (w/o Sliding Roof)
| *1 | Protective Tape |
| *a | Front |
Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws and remove the No. 1 room light lens.
| *1 | Protective Tape |
| *a | Front |
Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws as shown in the illustration and remove the No. 1 room light housing.
| *1 | Room Light Switch Base |
Using a screwdriver, disengage the 4 claws and disconnect the room light switch base from the No. 1 room light housing.
81360T
2.REMOVE SPOT LIGHT ASSEMBLY (w/ Sliding Roof)
| *a | Front |
Using a moulding remover, disengage the 4 claws.
Disconnect the connector and remove the spot light assembly.
81360U
3.REMOVE SPOT LIGHT BULB (w/ Sliding Roof)
Turn the 2 spot light sockets with the 2 spot light bulbs in the direction indicated by the arrows in the illustration and remove them as a unit.
Remove the 2 spot light bulbs from the 2 spot light sockets.