Home › Vehicle Interior › LIGHTING (INT) › VANITY LIGHT SWITCH
RM2040EQ _58 Vehicle Interior _014724 LIGHTING (INT) _0075067 VANITY LIGHT SWITCH G

LIGHTING (INT)  VANITY LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 74320 1.INSPECT VISOR ASSEMBLY LH

a.

Inspect the vanity light switch.

i.
E224621
1.115,2.958 1.198,2.208 1.198,2.208 1.417,2.208 false 2,2.563 2.063,2 2.063,2 2.167,2 false 1.792,3.771 1.875,4.156 1.875,4.156 2.021,4.156 false 0.115,0.042 0.302,0.229 0.188,0.188 10 false *a 1.458,2.125 1.646,2.313 0.188,0.188 10 false *1 2.177,1.906 2.365,2.094 0.188,0.188 10 false *b 2.031,4.063 2.219,4.25 0.188,0.188 10 false *c
*a Component without harness connected
(Visor Assembly LH)
*b Visor up
*c Visor down
*1 Mirror Cover


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Visor up 10 kΩ or higher
1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
1 - 2 Mirror cover fully open with visor down Below 1 Ω


If the result is not as specified, replace the visor assembly LH.



Hide 74310 2.INSPECT VISOR ASSEMBLY RH

a.

Inspect the vanity light switch.

i.
E224622
2.302,2.927 2.198,2.219 2.198,2.219 1.979,2.219 false 0.958,2.365 0.875,1.74 0.875,1.74 0.781,1.74 false 1.604,3.729 1.521,4.073 1.521,4.073 1.385,4.073 false 0.146,0.083 0.531,0.49 0.385,0.406 10 false *a 1.792,2.125 1.979,2.313 0.188,0.188 10 false *1 0.583,1.635 0.771,1.823 0.188,0.188 10 false *b 1.188,3.979 1.375,4.167 0.188,0.188 10 false *c
*a Component without harness connected
(Visor Assembly RH)
*b Visor up
*c Visor down
*1 Mirror Cover


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Visor up 10 kΩ or higher
1 - 2 Mirror cover fully closed with visor down 10 kΩ or higher
1 - 2 Mirror cover fully open with visor down Below 1 Ω


If the result is not as specified, replace the visor assembly RH.