PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected.
| System | See Procedure |
|---|---|
| Parking Assist Monitor System | ( )
|
PRECAUTIONS WHEN USING INTELLIGENT TESTER
When using the intelligent tester with the power switch off to troubleshoot:
Connect the intelligent tester to the vehicle, and turn the courtesy light switch on and off at 1.5-second intervals until communication between the intelligent tester and the vehicle begins.
After all DTCs are cleared, check if the trouble occurs again 6 seconds after the power switch is turned to on (IG).