FREEZE FRAME DATA
Whenever a meter DTC is detected, the meter ECU stores the current vehicle state as Freeze Frame Data.
CHECK FREEZE FRAME DATA
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / DTC.
According to the intelligent tester display, select the trouble code data display with Freeze Frame Data.
Read the Freeze Frame Data recorded when the DTC was set.
| Tester Display | Condition | Displayed Item |
|---|---|---|
| U0100 | Lost Communication with ECM/PCM "A" | ·
TRIP ·
Elapsed time after power switch on (READY) |
| U0129 | Lost Communication with Brake System Control Module | ·
TRIP ·
Elapsed time after power switch on (READY) |
| U0131 | Lost Communication with Power Steering Control | ·
TRIP ·
Elapsed time after power switch on (READY) |
| U0142 | Lost Communication with Body Control Module "B" | ·
TRIP ·
Elapsed time after power switch on (READY) |
| U0151 | Lost Communication with Restraints Control Module | ·
TRIP ·
Elapsed time after power switch on (READY) |
CLEAR FREEZE FRAME DATA
Clearing the DTCs will also clear the Freeze Frame Data.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Clear DTCs and Freeze Frame Data (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).