Home › Vehicle Interior › METER / GAUGE / DISPLAY › CLOCK
RM2040EQ _58 Vehicle Interior _014725 METER / GAUGE / DISPLAY _0075076 CLOCK G

METER / GAUGE / DISPLAY  CLOCK  INSPECTION  


PROCEDURE

Hide 83910G 1.INSPECT CLOCK ASSEMBLY

a.
B293365
1.729,0.854 1.729,0.333 false 1.208,2.208 1.208,1.854 false 1.729,2.208 1.729,1.854 false 2.25,2.208 2.25,1.854 false 1.198,0.844 1.198,0.635 1.198,0.635 2.24,0.635 false 2.24,0.635 2.24,0.854 false 1.646,0.135 1.844,0.375 0.198,0.24 10 false *a 1.135,2.24 1.365,2.479 0.229,0.24 10 false *b 1.646,2.24 1.896,2.458 0.25,0.219 10 false *c 2.177,2.24 2.417,2.479 0.24,0.24 10 false *d 0.531,2.844 0.76,3.073 0.229,0.229 10 false *e
*a Indicator A
*b Indicator B
*c Indicator C
*d Indicator D
*e Component without harness connected (Clock Assembly)


Apply battery voltage to the connector according to the table below.

OK:
Connection Result
Battery positive (+) - Terminal 2
Battery negative (-) - Terminal 1
Indicator A comes on
Battery positive (+) - Terminal 8
Battery negative (-) - Terminal 7
Indicator B comes on
Battery positive (+) - Terminal 8
Battery negative (-) - Terminal 6
Indicator C comes on
Battery positive (+) - Terminal 8
Battery negative (-) - Terminal 5
Indicator D comes on


If the result is not as specified, replace the clock assembly.