1.INSTALL REAR SIDE SEATBACK ASSEMBLY LH
Place the rear side seatback assembly LH in the cabin.
Be careful not to damage the vehicle body.
Engage the hook to install the rear side seatback assembly LH with the bolt.
Pass the rear seat outer belt through the rear seat shoulder belt guide LH.
2.INSTALL REAR SIDE SEATBACK ASSEMBLY RH
Place the rear side seatback assembly RH in the cabin.
Be careful not to damage the vehicle body.
Engage the hook to install the rear side seatback assembly RH with the bolt.
Pass the rear seat outer belt through the rear seat shoulder belt guide RH.
3.INSTALL REAR SEATBACK ASSEMBLY LH
Place the rear seatback assembly LH in the cabin.
Be careful not to damage the vehicle body.
Install the rear seatback assembly LH with the 2 bolts.
| *1 | Fastener |
Engage the fastener as shown in the illustration.
Raise the rear seatback assembly LH.
Pass the rear seat inner with center belt assembly LH through the rear seat center shoulder belt guide.
64277C
4.INSTALL NO. 2 ROOM PARTITION COVER
Engage the guide and claw to install the No. 2 room partition cover.
5.INSTALL REAR SEATBACK ASSEMBLY RH
Place the rear seatback assembly RH in the cabin.
Be careful not to damage the vehicle body.
Install the rear seatback assembly RH with the 2 bolts.
| *1 | Fastener |
Engage the fastener as shown in the illustration.
Raise the rear seatback assembly RH.
72693
6.INSTALL REAR SEAT CUSHION LOCK HOOK
Engage the claw to install a new rear seat cushion lock hook.
Rear seat cushion lock hooks must not be reused.
The illustration is for the RH side. The LH side is the opposite of the RH side.
7.INSTALL REAR SEAT CUSHION ASSEMBLY
Place the rear seat cushion assembly in the cabin.
Be careful not to damage the vehicle body.
Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.
Confirm that the rear seat cushion assembly is firmly installed.
When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.