DATA LIST
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter or Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| P-Seatbelt Buckle SW | Front passenger seat belt buckle switch signal | ON or OFF | ON: Front passenger seat belt unfastened
OFF: Front passenger seat belt fastened |
- |
| 2nd-Row Seatbelt Buckle (R) | Rear RH seat belt buckle switch signal | ON or OFF | OFF: Rear RH seat belt fastened
ON: Rear RH seat belt not fastened |
- |
| 2nd-Row Seatbelt Buckle (L) | Rear LH seat belt buckle switch signal | ON or OFF | OFF: Rear LH seat belt fastened
ON: Rear LH seat belt not fastened |
- |
| 2nd-Row Seatbelt Buckle (C) | Rear center seat belt buckle switch signal | ON or OFF | OFF: Rear center seat belt fastened
ON: Rear center seat belt not fastened |
- |
| Driver Side Seatbelt Warning Buzzer | Driver seat belt warning buzzer | ON or OFF | Customized value displayed | - |
| P-Seatbelt Warning Buzzer | Front passenger seat belt warning buzzer | ON or OFF | Customized value displayed | - |
| Rear Seatbelt Warning Buzzer | Rear seat belt warning buzzer | OFF or ON | Customized value displayed | - |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| RR Door Courtesy SW | Rear door courtesy light switch RH | CLOSE or OPEN | CLOSE: Rear door RH closed
OPEN: Rear door RH open |
- |
| RL Door Courtesy SW | Rear door courtesy light switch LH | CLOSE or OPEN | CLOSE: Rear door LH closed
OPEN: Rear door LH open |
- |
| D Seat Buckle SW | Driver seat belt buckle switch | ON or OFF | ON: Driver seat belt fastened
OFF: Driver seat belt unfastened |
- |
ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Driver Side Seat Belt | Seat belt warning light | OFF/ON | - |
| Rear Seat Belt | Rear seat belt warning light | OFF/ON | - |