73480
1.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
Check the ELR function.
| *1 | Retractor |
| *a | Unlocked |
| *b | Locked |
| *c | 45° |
Before installing the rear seat inner with center belt assembly LH, check the ELR function.
Do not disassemble the retractor.
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
If the result is not as specified, replace the rear seat inner with center belt assembly LH.
Check the buckle switch.
| *a | Component without harness connected
(Rear Seat Inner with Center Belt Assembly LH) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Rear LH seat belt not fastened | Below 1 Ω |
| 1 - 2 | Rear LH seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the rear seat inner with center belt assembly LH.
73470B
2.INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH
Inspect the rear seat inner with center belt assembly RH (for RH).
| *a | Component without harness connected
(Rear Seat Inner with Center Belt Assembly RH (for RH)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Rear RH seat belt not fastened | Below 1 Ω |
| 1 - 2 | Rear RH seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the rear seat inner with center belt assembly RH.
Inspect the rear seat inner with center belt assembly RH (for center).
| *a | Component without harness connected
(Rear Seat Inner with Center Belt Assembly RH (for center)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Rear center seat belt not fastened | Below 1 Ω |
| 1 - 2 | Rear center seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the rear seat inner with center belt assembly RH.