INITIALIZATION SERVO MOTOR
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Press the A/C OFF switch.
Turn the intelligent tester on.
Enter the following menus: Body / Air Conditioner / Utility / Servomotor Initialization.
According to the intelligent tester display, perform servomotor initialization.
| Tester Display |
|---|
| Servomotor Initialization |
During initialization, the A/C AUTO indicator light comes on, and then goes off when initialization has finished.
According to the intelligent tester display, select the "Exit" switch to finish initialization.