Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM2040EQ _59 Vehicle Exterior _014733 WINDOW / GLASS _0075142 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Jam Protection Function does not Operate  


DESCRIPTION

The jam protection function operates within a specified range during the manual up or auto up operation.

CAUTION / NOTICE / HINT

NOTICE:

If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).


PROCEDURE

1.PERFORM INITIALIZATION (DRIVER DOOR WINDOW MOTOR)
a.

Initialize the power window regulator motor assembly (for driver door).

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (FOR DRIVER DOOR))
2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (FOR DRIVER DOOR))
a.

Check if the power window auto up and down function operate normally.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK

OK:

Driver door auto up and down function is normal.



Result:
Proceed to
OK
NG



OK

3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE
a.

Check if the jam protection function operates normally for the driver door power window.

HINT:

The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.


OK:

Jam protection function operates normally.



Result:
Proceed to
OK
NG



OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR)