63650A
1.INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY)
| *a | Component without harness connected
(Sliding Roof Switch (Roof Console Box Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 (UP) - 10 (GND) | UP switch is pressed | Below 1 Ω |
| 6 (UP) - 10 (GND) | UP switch is not pressed | 10 kΩ or higher |
| 7 (DOWN) - 10 (GND) | DOWN switch is pressed | Below 1 Ω |
| 7 (DOWN) - 10 (GND) | DOWN switch is not pressed | 10 kΩ or higher |
| 8 (OPN) - 10 (GND) | OPEN switch is pressed | Below 1 Ω |
| 8 (OPN) - 10 (GND) | OPEN switch is not pressed | 10 kΩ or higher |
| 9 (CLS) - 10 (GND) | CLOSE switch is pressed | Below 1 Ω |
| 9 (CLS) - 10 (GND) | CLOSE switch is not pressed | 10 kΩ or higher |
If the result is not as specified, replace the sliding roof switch (roof console box assembly).