Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT
RM2040EQ _59 Vehicle Exterior _014735 DOOR / HATCH _0075149 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 53450A 1.INSTALL HOOD SUPPORT ASSEMBLY

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.



a.

When reusing the hood support assembly:

i.
B277174

Install the 2 stop rings to the hood support assembly.



b.
B277175

Install the hood support assembly.

NOTICE:

Install the hood support assembly while supporting the hood by hand.



c.

Check that the hood support assembly is engaged in the ball joint and it cannot be pulled out.