After installing the torsion bar, use your hand to open and close the luggage door. Make sure the luggage door can open and close smoothly.
64711
1.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
Remove the luggage compartment floor mat.
58387
2.REMOVE REAR FLOOR FINISH PLATE
Remove the 5 clips.
Disengage the 4 clips and remove the rear floor finish plate.
64717A
3.REMOVE LUGGAGE COMPARTMENT FRONT TRIM COVER
Disengage the 8 fasteners.
Disengage the 2 claws and remove the luggage compartment front trim cover.
64725D
4.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
| *1 | Pin |
Push the 2 pins and remove the 2 No. 1 luggage compartment trim hooks.
64722
5.REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH
Remove the 3 clips.
Disengage the fastener and remove the luggage compartment inner trim cover LH.
64721
6.REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER RH
Remove the 3 clips.
Disengage the fastener and remove the luggage compartment inner trim cover RH.
64572
7.REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER LH
Disengage the 4 claws and remove the luggage compartment door hinge cover LH.
64571B
8.REMOVE LUGGAGE COMPARTMENT DOOR HINGE COVER RH
Use the same procedure as for the LH side.
64532
9.REMOVE LUGGAGE DOOR HINGE TORSION BAR LH
Disengage the hook in the order indicated in the illustration and disconnect the rear seatback lock sub-assembly RH (rear seatback lock control cable RH).
| *1 | Protective Tape |
Put protective tape around the luggage door hinge.
Using SST, disconnect the luggage door hinge torsion bar LH from the luggage door hinge and the left side of the vehicle body as shown in the illustration.
Disengage the 2 claws as shown in the illustration.
Disconnect the luggage door hinge torsion bar LH from the luggage compartment door torsion bar support as shown in the illustration.
Remove the luggage door hinge torsion bar LH from the right side of the vehicle body as shown in the illustration.
64531
10.REMOVE LUGGAGE DOOR HINGE TORSION BAR RH
| *1 | Protective Tape |
Put protective tape around the luggage door hinge.
Using SST, disconnect the luggage door hinge torsion bar RH from the luggage door hinge and the right side of the vehicle body as shown in the illustration.
Disconnect the luggage door hinge torsion bar RH from the luggage compartment door torsion bar support as shown in the illustration.
Remove the luggage door hinge torsion bar RH from the left side of the vehicle body as shown in the illustration.
64127B
11.REMOVE LUGGAGE COMPARTMENT DOOR TORSION BAR SUPPORT
Remove the luggage compartment door torsion bar support as shown in the illustration.
Make sure to replace the luggage compartment door torsion bar support with a new one.