Use the same procedure for both the RH and LH sides.
The procedure described below is for the RH side.
87931
1.REMOVE OUTER MIRROR
| *1 | Protective Tape |
Apply protective tape to the area shown in the illustration.
Push the upper part of the mirror surface and tilt it.
w/o Blind Spot Monitor System:
| *1 | Protective Tape |
Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the outer mirror as shown in the illustration.
w/ Blind Spot Monitor System:
| *1 | Protective Tape |
Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and disconnect the outer mirror as shown in the illustration.
Disconnect the connectors and remove the outer mirror.
Do not bend the tabs excessively to prevent them from being damaged.
If the tabs are damaged, replace the outer rear view mirror with a new one.