Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE › 2012.02–2015.04
RM2040EQ _59 Vehicle Exterior _014737 WIPER / WASHER _0075166 WASHER NOZZLE G

WIPER / WASHER  WASHER NOZZLE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85035 1.INSPECT WASHER NOZZLE SUB-ASSEMBLY

a.

With the engine running, check the position that the washer fluid hits the windshield.

Standard:

Washer fluid hits the windshield in the areas shown in the illustration.


E231014
1.885,2.531 2.115,2.531 false 2.125,3.313 2.313,3.313 false 2.125,4.198 1.854,4.198 false 5.281,2.531 5.073,2.531 false 5.052,3.292 4.719,3.292 false 5.052,4.198 5.323,4.198 false 4.104,1.208 4.438,1.5 0.333,0.292 10 false A 3.01,1.208 3.333,1.49 0.323,0.281 10 false A 3.885,5.552 4.188,5.802 0.302,0.25 10 false C 3.229,5.552 3.542,5.833 0.313,0.281 10 false C 4.865,4.594 5.167,4.875 0.302,0.281 10 false B 4.896,2.417 5.177,2.667 0.281,0.25 10 false *a 4.542,3.198 4.833,3.427 0.292,0.229 10 false *b 5.354,4.094 5.74,4.354 0.385,0.26 10 false *c 2.135,2.427 2.5,2.677 0.365,0.25 10 false *a 2.323,3.219 2.635,3.448 0.313,0.229 10 false *b 1.667,4.094 1.99,4.375 0.323,0.281 10 false *c
*a Upper Limit *b Standard
*c Lower Limit - -


Standard Clearance
Area Measurement Area Measurement
A 300.0 mm (11.8 in.) B 145.0 mm (5.71 in.)
C 170.0 mm (6.69 in.) - -

HINT:

If the result is not as specified, replace the washer nozzle sub-assembly.