Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR › 2012.02–2015.04
RM2040EQ _59 Vehicle Exterior _014737 WIPER / WASHER _0075168 FRONT WIPER MOTOR A

WIPER / WASHER  FRONT WIPER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

a.
E230053

Remove the nut and front wiper arm and blade assembly RH.


Hide 2.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH

a.
E230054

Remove the nut and front wiper arm and blade assembly LH.


Hide 53866J 3.REMOVE FRONT FENDER TO COWL SIDE SEAL RH

a.
E230055

Disengage the 2 clips and 3 guides, and remove the front fender to cowl side seal RH as shown in the illustration.


Hide 53867H 4.REMOVE FRONT FENDER TO COWL SIDE SEAL LH

HINT:

Use the same procedure as for the RH side.


Hide 55781E 5.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

a.

Disengage the 6 claws and guide as shown in the illustration.

E230057


b.

Disengage the 8 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.

E230066


Hide 6.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

a.

Operate the wiper and stop the windshield wiper motor at the automatic stop position.


b.
E227522C04
2.542,2.698 1.833,2.813 false 1.656,2.708 2.063,2.969 0.406,0.26 10 false *1
*1 Motor Grommet


Disengage the 2 clamps and then disconnect the connector.


c.

Remove the 2 bolts.


d.

Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.

NOTICE:

Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.



Hide 85110 7.REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

a.
E230059C02
1.948,0.469 1.313,0.469 false 1.406,0.708 0.979,0.615 false 1.125,0.354 1.396,0.604 0.271,0.25 10 false *2 0.781,0.49 1.198,0.813 0.417,0.323 10 false *1
*1 Protective Tape
*2 No. 1 Rod


Using a screwdriver, separate the No. 1 rod from the windshield wiper motor assembly as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



b.
E230748

Using a T30 "TORX" socket wrench, remove the 2 bolts and windshield wiper motor assembly from the wiper link assembly.