Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM2040EQ _59 Vehicle Exterior _014737 WIPER / WASHER _0075169 WIPER SWITCH G

WIPER / WASHER  WIPER SWITCH  INSPECTION  


PROCEDURE

Hide 84650 1.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (W/O AUTO WIPER SYSTEM)

a.
E226489
0.177,1.115 0.635,1.385 0.458,0.271 2.813,1.115 3.271,1.385 0.458,0.271 0.865,1.833 0.948,1.458 false 1.385,1.458 1.438,1.844 false 1.792,1.073 1.688,0.625 false 2.01,1.083 2.021,0.625 false 2.281,1.083 2.385,0.615 false 2.51,1.083 2.74,0.656 false 0.167,0.167 0.583,0.417 0.417,0.25 10 false *a 0.313,1.156 0.708,1.438 0.396,0.281 10 false I31 2.948,1.156 3.333,1.438 0.385,0.281 10 false I32 2.708,0.479 3.031,0.708 0.323,0.229 10 false +2 2.313,0.417 2.635,0.646 0.323,0.229 10 false +1 1.896,0.417 2.188,0.635 0.292,0.219 10 false +B 1.531,0.438 1.885,0.667 0.354,0.229 10 false +S 0.719,1.844 1.198,2.115 0.479,0.271 10 false EW 1.302,1.844 1.75,2.083 0.448,0.24 10 false WF
*a Component without harness connected
(Windshield Wiper Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Front Wiper Switch
Tester Connection Switch Condition Specified Condition
I32-4 (+S) - I32-2 (+1) OFF Below 1 Ω
INT
I32-3 (+B) - I32-2 (+1) MIST
LO
I32-3 (+B) - I32-1 (+2) HI

Front Washer Switch
Tester Connection Switch Condition Specified Condition
I31-7 (EW) - I31-4 (WF) ON Below 1 Ω
OFF 10 kΩ or higher


If the result is not as specified, replace the windshield wiper switch assembly.


Hide 84650 2.INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (W/ AUTO WIPER SYSTEM)

a.
E227242
0.271,1.229 0.729,1.5 0.458,0.271 2.698,1.229 3.156,1.5 0.458,0.271 2.375,3.563 1.146,2.833 false 2.302,3.927 1.031,4.219 false 2.375,3.688 0.75,3.188 false 2.344,3.802 0.719,3.698 false 2.135,1.583 2.406,1.969 false 1.927,1.583 1.792,1.927 false 1.021,1.875 1.063,1.583 false 1.438,1.583 1.458,1.885 false 2.031,1.594 2.083,2.125 false 2.25,1.594 2.677,1.854 false 1.792,1.302 1.688,0.865 false 1.979,1.292 1.979,0.833 false 2.167,1.302 2.271,0.833 false 2.365,1.313 2.594,0.885 false 0.844,4.135 1.302,4.406 0.458,0.271 10 false P1 0.479,3.594 0.854,3.823 0.375,0.229 10 false P2 0.51,3.083 1,3.385 0.49,0.302 10 false P3 0.948,2.729 1.49,2.979 0.542,0.25 10 false P4 0.167,2.5 0.583,2.75 0.417,0.25 10 false *1 0.167,0.167 0.5,0.417 0.333,0.25 10 false *a 0.417,1.271 0.823,1.51 0.406,0.24 10 false I31 2.844,1.271 3.198,1.5 0.354,0.229 10 false I32 2.531,0.719 2.865,0.969 0.333,0.25 10 false +2 2.177,0.677 2.49,0.917 0.313,0.24 10 false +1 1.885,0.677 2.208,0.938 0.323,0.26 10 false +B 1.542,0.698 1.875,0.938 0.333,0.24 10 false +S 2.719,1.781 3.021,2.021 0.302,0.24 10 false E 2.302,1.979 2.865,2.25 0.563,0.271 10 false AUTO 0.865,1.885 1.24,2.125 0.375,0.24 10 false EW 1.333,1.885 1.771,2.167 0.438,0.281 10 false WF 1.958,2.156 2.438,2.396 0.479,0.24 10 false VR2 1.635,1.958 2.104,2.24 0.469,0.281 10 false VR1
*1 Windshield Wiper Switch Assembly (Adjusting Ring Position)
*a Component without harness connected
(Windshield Wiper Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Front Wiper Switch
Tester Connection Switch Condition Specified Condition
I32-2 (+1) - I32-4 (+S) OFF Below 1 Ω
I32-2 (+1) - I32-3 (+B) MIST
LO
I32-3 (+B) - I32-1 (+2) HI
I32-7 (AUTO) - I32-6 (E) AUTO

Front Washer Switch
Tester Connection Switch Condition Specified Condition
I31-7 (EW) - I31-4 (WF) ON Below 1 Ω
OFF 10 kΩ or higher

Adjusting Ring*
Tester Connection Switch Condition Specified Condition
I32-9 (VR1) - I32-8 (VR2) P1 209 to 231 Ω
P2 114 to 126 Ω
P3 58.9 to 65.1 Ω
P4 Below 1 Ω


HINT:

*: The rain sensor sensitivity can be adjusted by the windshield wiper switch adjusting ring.


If the result is not as specified, replace the windshield wiper switch assembly.