Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM2040EQ _59 Vehicle Exterior _014737 WIPER / WASHER _0075170 WASHER MOTOR G

WIPER / WASHER  WASHER MOTOR  INSPECTION  


PROCEDURE

Hide 85310 1.INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.

Remove the washer jar.


b.

Disconnect the windshield washer motor and pump assembly connector.

HINT:

The check should be performed with the windshield washer motor and pump assembly installed on the washer jar.



c.

Fill the washer jar with washer fluid.


d.
E132855
0.396,1.063 0.865,1.344 0.469,0.281 0.24,0.115 0.719,0.469 0.479,0.354 10 *a 0.5,1.104 0.969,1.385 0.469,0.281 10 A54
*a Component without harness connected
(Windshield Washer Motor and Pump Assembly)


Connect an auxiliary battery positive (+) lead to terminal A54-1 of the windshield washer motor and pump assembly, and a negative (-) lead to terminal A54-2.


e.

Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.


If the result is not as specified, replace the windshield washer motor and pump assembly.