Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM2040EQ _59 Vehicle Exterior _014737 WIPER / WASHER _0075171 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  INSTALLATION  


PROCEDURE

Hide 89944 1.INSTALL RAIN SENSOR TAPE

HINT:

Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.


a.

Clean the rain sensor sensing portion with a piece of cloth, etc.


b.
E228043
2.135,1.594 2.771,1.594 false 0.615,2.156 0.906,2.406 0.292,0.25 10 false A 1.313,2.958 1.646,3.24 0.333,0.281 10 false B 2.813,1.479 3.177,1.76 0.365,0.281 10 false *1
*1 Rain Sensor Tape


Peel off the smaller release sheet, and then attach the rain sensor tape to the rain sensor sensing portion as shown in the illustration.

Standard Clearance
Area Measurement
A 13.5 mm (0.532 in.)
B 7.25 mm (0.285 in.)

NOTICE:

Use your fingers to push out any air bubbles from under the tape.



Hide 89941 2.INSTALL RAIN SENSOR

a.

Clean the windshield glass with a piece of cloth, etc.

NOTICE:
·

Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

·

If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.




b.

When installing a new rain sensor or replacing the rain sensor tape:

i.

Peel off the release sheet.

HINT:

Do not touch the silicone coated surfaces.




c.
E235213
1.26,1.635 0.698,1.635 false 2.438,1.646 2.792,1.99 0.354,0.344 10 false (1) 0.698,1.854 1.083,2.146 0.385,0.292 10 false (2) 0.49,1.521 0.802,1.729 0.313,0.208 10 false *1
*1 Stopper


Gradually attach the rain sensor to the glass surface to prevent air bubbles from forming between them.

HINT:

Do not touch the silicone coated or glass surfaces.



d.

Push in the stopper.


e.

Connect the connector.


Hide 89943 3.INSTALL RAIN SENSOR COVER

a.

Engage the 2 claws to install the rain sensor cover.