Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM2040EQ _59 Vehicle Exterior _014737 WIPER / WASHER _0075171 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT RAIN SENSOR

a.
E169141
1.469,1.438 2,1.708 0.531,0.271 2.042,2.438 2.563,1.885 false 1.573,2.406 1.042,1.844 false 1.635,1.479 2.094,1.74 0.458,0.26 10 false S1 0.885,1.667 1.354,1.906 0.469,0.24 10 false ES 2.5,1.708 2.979,1.979 0.479,0.271 10 false SIG 0.167,0.167 0.667,0.427 0.5,0.26 10 false *a
*a Front view of wire harness connector
(to Rain Sensor)


Disconnect the S1 rain sensor connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
S1-4 (SIG) - S1-2 (ES) Power switch on (IG) 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
S1-2 (ES) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the harness or connector.


d.
E141656
0.563,1.615 1.031,1.875 0.469,0.26 1.979,1.979 2.292,1.563 false 1.688,1.417 1.813,1.979 false 0.167,0.167 0.667,0.5 0.5,0.333 10 false *a 2.198,1.375 2.729,1.635 0.531,0.26 10 false MPX 1.531,1.229 1.906,1.448 0.375,0.219 10 false ES 0.708,1.646 1.156,1.896 0.448,0.25 10 false S1
*a Component with harness connected
(Rain Sensor)


Reconnect the rain sensor connector.


e.

Connect an oscilloscope to the rain sensor connector.


f.

Check for pulses.

OK:
Tester Connection Condition Specified Condition
S1-1 (MPX) - S1-2 (ES) Power switch on (IG) Pulse generation


If the result is not as specified, the rain sensor may have a malfunction.