This circuit detects the state of the power switch, and sends it to the AFS ECU (headlight swivel ECU assembly).
| *a | Front view of wire harness connector
(to AFS ECU (Headlight Swivel ECU Assembly)) |
Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-15 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-22 (E1) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG