Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › 2012.02–2015.04
RM2040EQ _59 Vehicle Exterior _014738 LIGHTING (EXT) _0075174 AUTOMATIC HIGH BEAM SYSTEM U

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  FAIL-SAFE CHART  


AUTOMATIC HIGH BEAM SYSTEM


a.

The main body ECU (multiplex network body ECU) operates in fail-safe mode if an abnormal condition such as those listed below has been detected.

Item Abnormality Detection Condition Return Condition Warning indicator
Steering Angle Sensor Signal Malfunction Steering angle sensor malfunction is detected. Steering angle sensor malfunction is not detected, and power switch is turned on (IG) again. Not illuminated
Steering angle sensor data continuity invalid is detected. Steering angle sensor data continuity invalid flag is detected. Not illuminated
Speed Sensor Signal Malfunction Abnormal speed sensor signal is detected. Normal speed sensor signal is detected. Flashes
CAN Communication Signal Malfunction Normal CAN communication signal is not detected. Normal CAN communication signal is detected. Flashes
Automatic High Beam Sensor Communication stopped. Normal communication signal is detected. Flashes