Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY
RM2040EQ _59 Vehicle Exterior _014738 LIGHTING (EXT) _0075178 REAR COMBINATION LIGHT ASSEMBLY G

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR COMBINATION LIGHT ASSEMBLY LH

a.
E220289
1.49,0.333 1.948,0.615 0.458,0.281 1.49,2.24 1.948,2.521 0.458,0.281 0.938,1.5 1.479,1.5 false 2.458,1.5 1.917,1.5 false 0.854,3.385 1.396,3.385 false 2.604,3.385 2.063,3.385 false 2.604,2.875 1.729,3.281 false 0.177,0.156 0.635,0.583 0.458,0.427 10 false *a 0.771,1.417 1.125,1.781 0.354,0.365 10 false B 1.615,0.385 2.063,0.76 0.448,0.375 10 false T8 1.615,2.292 2.063,2.615 0.448,0.323 10 false T9 2.5,1.417 2.823,1.771 0.323,0.354 10 false E 0.688,3.302 0.979,3.635 0.292,0.333 10 false E 2.635,3.302 3.063,3.625 0.427,0.323 10 false STP 2.635,2.792 3.104,3.135 0.469,0.344 10 false TL
*a Front view of wire harness connector
(to Rear Combination Light Assembly LH)


Disconnect the connector from the rear combination light assembly LH.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T8-1 (B) - T8-2 (E) Turn signal switch in neutral position Below 1 V
Turn signal switch in left turn position 11 to 14 V (60 to 120 times per minute)
T9-2 (TL) - T9-1 (E) Light control switch off Below 1 V
Light control switch in tail position 11 to 14 V
T9-3 (STP) - T9-1 (E) Brake pedal released Below 1 V
Brake pedal depressed 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.


Hide 2.INSPECT REAR COMBINATION LIGHT ASSEMBLY RH

a.
E220289
1.49,0.333 1.948,0.615 0.458,0.281 1.49,2.24 1.948,2.521 0.458,0.281 0.938,1.5 1.479,1.5 false 2.458,1.5 1.917,1.5 false 0.854,3.385 1.396,3.385 false 2.604,3.385 2.063,3.385 false 2.604,2.875 1.729,3.281 false 0.177,0.156 0.771,0.698 0.594,0.542 10 false *a 0.792,1.417 1.177,1.792 0.385,0.375 10 false B 1.583,0.385 2.292,0.802 0.708,0.417 10 false T13 1.583,2.292 2.5,2.854 0.917,0.563 10 false T12 2.5,1.417 2.906,1.792 0.406,0.375 10 false E 0.688,3.302 1.073,3.792 0.385,0.49 10 false E 2.635,3.302 3.177,3.813 0.542,0.51 10 false STP 2.635,2.792 3.052,3.198 0.417,0.406 10 false TL
*a Front view of wire harness connector
(to Rear Combination Light Assembly RH)


Disconnect the connector from the rear combination light assembly RH.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T13-1 (B) - T13-2 (E) Turn signal switch in neutral position Below 1 V
Turn signal switch in right turn position 11 to 14 V (60 to 120 times per minute)
T12-2 (TL) - T12-1 (E) Light control switch off Below 1 V
Light control switch in tail position 11 to 14 V
T12-3 (STP) - T12-1 (E) Brake pedal released Below 1 V
Brake pedal depressed 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.