Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY
RM2040EQ _59 Vehicle Exterior _014738 LIGHTING (EXT) _0075179 REAR LIGHT ASSEMBLY G

LIGHTING (EXT)  REAR LIGHT ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR LIGHT ASSEMBLY LH

a.
E220265
1.49,0.125 1.948,0.406 0.458,0.281 1.438,1.344 1.156,1.698 false 2,1.344 2.281,1.698 false 0.177,0.167 0.635,0.667 0.458,0.5 10 false *a 1.042,1.719 1.552,2.104 0.51,0.385 10 false E 2.292,1.719 2.719,2.063 0.427,0.344 10 false B 1.583,0.188 2.354,0.677 0.771,0.49 10 false T18
*a Front view of wire harness connector
(to Rear Light Assembly LH)


Disconnect the connector from the rear light assembly LH.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T18-2 (B) - T18-1 (E) Power switch on (READY) and the shift lever not in R Below 1 V
Power switch on (READY) and the shift lever in R 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.


Hide 2.INSPECT REAR LIGHT ASSEMBLY RH

a.
E220265
1.49,0.125 1.948,0.406 0.458,0.281 1.438,1.344 1.156,1.698 false 2,1.344 2.281,1.698 false 0.177,0.167 0.542,0.448 0.365,0.281 10 false *a 1.042,1.719 1.396,2 0.354,0.281 10 false E 2.292,1.719 2.625,2 0.333,0.281 10 false B 1.583,0.188 2.125,0.583 0.542,0.396 10 false T17
*a Front view of wire harness connector
(to Rear Light Assembly RH)


Disconnect the connector from the rear light assembly RH.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T17-2 (B) - T17-1 (E) Power switch on (READY) and the shift lever not in R Below 1 V
Power switch on (READY) and the shift lever in R 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.