Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM2040EQ _59 Vehicle Exterior _014738 LIGHTING (EXT) _0075183 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 55900 1.INSPECT AIR CONDITIONING CONTROL ASSEMBLY (HAZARD SWITCH)

a.
E216456
1.25,0.604 1.563,1.156 false 2.146,0.604 1.833,1.156 false 2.042,0.406 2.344,0.583 0.302,0.177 10 false HAZ 0.969,0.406 1.313,0.583 0.344,0.177 10 false GND 0.167,0.146 0.646,0.531 0.479,0.385 10 false *a
*a Component without harness connected
(Air Conditioning Control Assembly (Hazard Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (HAZ) - 6 (GND) Hazard switch off 10 kΩ or higher
Hazard switch on Below 1 Ω


If the result is not as specified, replace the heater control switch board.