Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM2040EQ _59 Vehicle Exterior _014738 LIGHTING (EXT) _0075184 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.
E145496
0.177,0.052 0.427,0.344 0.25,0.292 10 false *a 0.625,2.563 0.875,2.854 0.25,0.292 10 false *b 1.292,2.563 1.542,2.854 0.25,0.292 10 false *c
*a Component without harness connected
(Stop Light Switch Assembly)
*b Not Pushed
*c Pushed


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Pushed 10 kΩ or higher
Not pushed Below 0.1 Ω
3 - 4 Pushed Below 200 Ω
Not pushed 10 kΩ or higher


If the result is not as specified, replace the stop light switch assembly.