Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM2040EQ _59 Vehicle Exterior _014738 LIGHTING (EXT) _0075185 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89120A 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.
E223976
0.083,0.06 0.305,0.253 0.222,0.193 10 *a 0.807,1.294 1.199,1.544 0.392,0.25 0.895,1.337 1.12,1.487 0.226,0.149 10 I61 2.286,1.592 2.659,1.741 0.373,0.149 10 CLTB 0.691,1.82 1.069,1.969 0.378,0.149 10 CLTE 1.91,1.675 2.261,1.675 false 1.56,1.503 1.107,1.821 false
*a Front view of wire harness connector
(to Automatic Light Control Sensor)


Disconnect the I61 automatic light control sensor connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I61-6 (CLTB) - I61-3 (CLTE) Power switch off Below 1 V
Power switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
I61-3 (CLTE) - Body ground Always Below 1 Ω


If the result is not as specified, there may be a malfunction on the wire harness side.


c.
E223977
0.155,0.11 0.357,0.266 0.203,0.156 10 *a 2.383,2.725 2.773,2.87 0.39,0.145 10 CLTS 2.535,2.376 2.921,2.52 0.385,0.145 10 CLTE 1.871,2.406 2.297,2.739 false 1.865,2.25 2.481,2.447 false 0.344,1.595 0.745,1.858 0.401,0.263 0.436,1.637 0.646,1.799 0.211,0.162 10 I61
*a Component with harness connected
(Automatic Light Control Sensor)


Reconnect the I61 automatic light control sensor connector.


d.

Connect an oscilloscope to the automatic light control sensor connector.


e.
E223978
2.953,1.027 3.297,1.187 0.344,0.16 10 GND 1.854,1.152 1.984,1.313 0.13,0.16 10 A

Check the waveform.

OK:
Tester Connection Tool Setting Condition Specified Condition
I61-3 (CLTE) - I61-5 (CLTS) 5 V/DIV., 5 ms./DIV Power switch on (IG), light control switch in AUTO position Correct waveform is as shown


HINT:

If the ambient light becomes brighter, width A becomes narrower.


If the result is not as specified, the automatic light control sensor may have a malfunction.