Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2012.02–2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075202 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Move the front bumper assembly into position and install the 3 clips.


b.

w/ Fog Light:

i.

Pull back the side of the front bumper assembly and connect each connector.

NOTICE:

Do not apply excessive force when pulling back the side of the front bumper assembly.


HINT:

Use the same procedure for the RH side and LH side.




c.
B311453

Engage the 3 claws to install the front bumper assembly.

HINT:

Use the same procedure for the RH side and LH side.



d.

Install the 6 screws.


e.
B279839C05
2.021,2.74 1.844,2.74 false 2.948,1.375 3.198,1.625 0.25,0.25 10 false *b 2.365,1.375 2.615,1.625 0.25,0.25 10 false *a 2.063,2.646 2.417,2.917 0.354,0.271 10 false *1
*1 Pin Hold Clip
*a Correct
*b Incorrect


Install the pin hold clip as shown in the illustration.

NOTICE:

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.


HINT:

Use the same procedure for the RH side and LH side.



f.

Install the clip.

HINT:

Use the same procedure for the RH side and LH side.



Hide 53111 2.INSTALL RADIATOR GRILLE SUB-ASSEMBLY

Hide 3.ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)