This circuit consists of the No. 1 clearance warning buzzer and clearance warning ECU assembly. An ECU-excited type buzzer is used. The ECU operates the buzzer using a sound pattern that changes depending on the distance to the obstacle.
Disconnect the I54 No. 1 clearance warning buzzer connector.
Disconnect the I82 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I82-14 (BBZ) - I54-1 (Z+) | Always | Below 1 Ω |
| I82-13 (ER) - I54-2 (Z-) | Always | Below 1 Ω |
| I82-14 (BBZ) - Body ground | Always | 10 kΩ or higher |
| I82-13 (ER) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG