When the rear sunshade switch is pushed, an operation signal is sent to the rear sunshade relay (rear window shade assembly).
Inspect the fuses for circuits related to this system before performing the following procedure.
| *a | Component without harness connected
(Rear Sunshade Switch Assembly) |
Remove the rear sunshade switch assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR SUNSHADE SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 (ECU) - 3 (E2) | Rear sunshade switch pushed | Below 1 Ω |
| 6 (ECU) - 3 (E2) | Rear sunshade switch not pushed | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N19 rear sunshade relay (rear window shade assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N19-5 (SW) - I50-6 (ECU) | Always | Below 1 Ω |
| N19-5 (SW) - Body ground | Always | 10 kΩ or higher |
| I50-3 (E2) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N19-8 (B) - Body ground | Power switch off | 11 to 14 V |
| N19-7 (IG) - Body ground | Power switch off | Below 1 V |
| N19-7 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N19-1 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG