Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014716 AUDIO / VIDEO _0076806 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  CD cannot be Inserted / Played or CD is Ejected Right After Insertion  


PROCEDURE

1.CHECK IF A PROPER CD IS INSERTED
a.

Make sure that the CD is an audio CD or a CD with an MP3 or WMA file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

OK:

CD is normal.


HINT:
·

Translucent or uniquely-shaped CDs cannot be played.

·

CDs with adhesive paper labels should not be played.

·

Commercial audio CDs can be played.

·

CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.

·

MP3 and WMA files on CD-ROMs, CD-Rs and CD-RWs can be played.

·

For details on playable CDs, refer to the Owner's Manual.




Result:
Proceed to
OK
NG



OK

2.CHECK THAT CD IS INSERTED PROPERLY

NG

CD IS FAULTY

2.CHECK THAT CD IS INSERTED PROPERLY
a.

Check whether or not the CD is inserted upside down.

OK:

CD is properly inserted.



Result:
Proceed to
OK
NG



OK

3.CLEAN CD AND RECHECK

NG

SET CD PROPERLY

3.CLEAN CD AND RECHECK
a.
I100151

Disc cleaning

i.

If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

OK:

Malfunction disappears.


NOTICE:

Do not use a conventional record cleaner or anti-static preservative.




Result:
Proceed to
OK
NG



OK

END (CD WAS DIRTY)

NG

4.REPLACE CD AND RECHECK
4.REPLACE CD AND RECHECK
a.

Replace the CD with a known good one and check that the malfunction disappears.

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

CD WAS FAULTY

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY