Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014716 AUDIO / VIDEO _0076806 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Radio Receiver Power Source Circuit  


DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM

E226165E71
0.396,0.76 2.01,0.979 1.615,0.219 10 false from Auxiliary Battery 0.344,1.573 1.792,1.75 1.448,0.177 10 false from ACC NO. 1 Relay 0.406,2.396 1.792,2.573 1.385,0.177 10 false from IG1 NO. 2 Relay 3.167,2.604 4.198,2.781 1.031,0.177 10 false ECU-IG1 NO. 2 3.375,1.021 4.01,1.198 0.635,0.177 10 false RADIO-B 3.354,1.813 4.021,1.99 0.667,0.177 10 false ECU-ACC 5.552,2.979 5.75,3.146 0.198,0.167 10 false 7 5.552,1.375 5.75,1.542 0.198,0.167 10 false 3 5.427,0.781 5.74,0.948 0.313,0.167 10 false I152 5.427,1.583 5.74,1.75 0.313,0.167 10 false I152 5.427,2.375 5.729,2.542 0.302,0.167 10 false I155 5.427,3.167 5.729,3.333 0.302,0.167 10 false I152 5.813,0.781 6.104,0.948 0.292,0.167 10 false +B1 5.813,1.583 6.25,1.75 0.438,0.167 10 false ACC1 5.813,2.375 5.99,2.542 0.177,0.167 10 false IG 5.813,3.167 6.25,3.333 0.438,0.167 10 false GND1 5.281,3.625 7.031,3.958 1.75,0.333 10 false Radio and Display Receiver Assembly 5.552,0.583 5.677,0.75 0.125,0.167 10 false 4 5.552,2.167 5.677,2.333 0.125,0.167 10 false 1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - AUXILIARY BATTERY, BODY GROUND)
a.

Disconnect the radio and display receiver assembly connectors.


b.

Measure the resistance according to the value(s) in the table below .

Standard Resistance:
Tester Connection Condition Specified Condition
I152-7 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I152-4 (+B1) - I152-7 (GND1) Power switch off 11 to 14 V
I152-3 (ACC1) - I152-7 (GND1) Power switch on (ACC) 11 to 14 V
I155-1 (IG) - I152-7 (GND1) Power switch on (IG) 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR