Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014716 AUDIO / VIDEO _0076806 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

E226166E93
3.708,1.021 3.833,1.188 0.125,0.167 10 false 1 5.208,1.021 5.333,1.188 0.125,0.167 10 false 6 4.563,1.969 4.885,2.135 0.323,0.167 10 false I154 4.563,2.146 6.958,2.375 2.396,0.229 10 false Radio and Display Receiver Assembly 2.667,1.417 3.177,1.583 0.51,0.167 10 false A42 2.656,1.594 3.781,1.979 1.125,0.385 10 false Parking Brake Switch Assembly 5.417,1.104 5.771,1.281 0.354,0.177 10 false PKB

PROCEDURE

1.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the radio and display receiver assembly connector.


b.

Disconnect the parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I154-6 (PKB) - A42-1 Always Below 1 Ω
I154-6 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR