These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B158D | Video Signal Stoppage | The internal video signal of the radio and display receiver assembly is interrupted | Radio and display receiver assembly |
| B15A0 | LAN Master Malfunction | When either condition below is met:
·
Bus malfunction ·
EEPROM error |
Radio and display receiver assembly |
| B15B0 | Display Screen Malfunction | Picture circuit (TFT unit) malfunction | Radio and display receiver assembly |
| B15B3 | Radio Tuner Malfunction | When one of the conditions below is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
Radio and display receiver assembly |
| B15B4 | CD Changer Malfunction | When one of the conditions below is met:
·
Mechanism drive signal malfunction ·
Load/Eject malfunction ·
Read mechanism malfunction ·
Mechanical malfunction |
Radio and display receiver assembly |
| B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Radio and display receiver assembly |
Clear the DTCs.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG